Teddy DualCustom Power Supply

Details  The Dual-Outlet power supply can be used to replace two small AC plug-in power adaptors that comes with many audio equipment, routers, NAS etc, and provides significant improvement in sound quality. The design is based on the experience gained with the TeddyCap family of power supplies for Naim Audio equipment, and uses the same technology. Sound In general, you’ll experience more clarity, tighter bass, more detail, better dynamics, natural voices, better soundstage etc. Performance The small power supply which is provided with most types of equipment is based on a technology called Switch Mode. Using this technology it is possible to create small, efficient, and low cost power supplies. Unfortunately due to their method of operation (high frequency capacitor charging), these power supplies are also very noisy, causing degradation in sound quality. As an alternative, several after market power supplies exist which are usually based on Linear Regulators. These regulators provides an improvement over the original power supply but as can be seen on the graph below are still limited in their performance. The Dual power supply is based on a superior regulator called SuperTeddyReg and provides a significant improvement over linear regulators. The following graph shows the noise level measurements of the original wall wart power supply (red line), an alternative power supply based on a Liner Regulator (blue line), and the Dual12 power supply (black line). The brown line is a zero Volt reference which is actually the measurement equipment internal noise. As can be seen the Dual12 power supply noise level is very close to the zero Volt reference. For more information about our power supplies read here… Interconnects The Dual-Outlet power supply is equipped with two high quality cables made of silver plated PTFE insulated wires. The cable capacitance is around 13pF/ft, and its resistance is also very low, around 10 milliohm/ft.